Comments on: Wi-Fi consumers cautioned to wait on new gear

Testers unhappy with new Wi-Fi equipment that complies with the draft version of 802.11n standard.

[locoHost]

My advice: Don't wait!

Prices are low, I got a Belkin Pre-N Mimo and the Mimo laptop card for $166. This thing is fast!!! 108Mbs is just as fast as a wired network. I had no idea my cable modem service was so fast. It was always squelched by my B network. The range is great. I took my laptop all the way accross the street to my neighbors and the signal hardly decreased a bar. The speed is tremendous and the range is awesome. For $166 why would anyone wait? The Belkin Pre-N Mimo is fantastic. I just had to share.

[markdoiron]

Thanks for That Comment

Thanks for the comment, locoHost. Of course, upgrading from B to N should have shown a tremendous improvement. I experienced the same thing when I upgraded from B to G (factor of four). However, then several other networks popped up in my neighborhood and all running in proprietary channel 6 center, spread frequency modes. This has wiped out pretty much every channel, and slowed my speed to about one-third. :-(

So, here's my question: Does N take care of this? It's supposed to be optimized for multipath, high interference environments, right? Did the testers test even test that? IOW: G to N in a clean environment may not gain much, but how about G to N in a spectrally dense environment? I didn't see in the article any mention of that.

mark d.

[Seaspray0]

Weakest link

I'm not surprised you got a boost from B to pre-N. Your comment about the range is most interesting; many of us are curious about how far N will go and how well it handles blockage like walls, ceilings, etc.

Given that high speed internet is on the order of 1.5MB/s, it is clearly going to be the weakest link of any home network for speed. Unless you share files and other resources between computers, the biggest concern you should have with wireless is range and reception. Wireless G will certainly xmit fast enough, but too often I've encountered problems with range and certainly with walls and ceilings killing the signal faster than anything else. This article makes me think that wireless N isn't ready enough when it comes to range. Anybody willing to dispute their test results on wireless N (not Pre-N), I'd like to hear it. My experience is that a wall will kill about 30% of wireless G signal. How does wireless N fare?

[inachu]

I agree don't wait buy now.

If this is just for your home network and everyone else is waiting for standards then this means more privacy for you.

tweak your netowrk for only the "N" standard and nobody else can hijack your connection!

wonderful!

[OneWithTech]

See what happens....

....to an Un-Regulated Technology like 802.11(x). Wifi
technology as a whole is suffering from the age old adage of "To
May Chefs Spoil the Broth" syndrome. No central control, just a
forum that likes to think it's in control.

1) Standards take to long to approve and decide on by the
current Wifi panel.

2) Companies like Linksys and DLink are exploiting 802.11(x) as
well as Bluetooth Technologies to extremes that weren't meant
to be.
IE. The art of using all 11 channels to send data over a Wifi
network not only hinders the affects of your neighbors wireless;
it also puts the original wireless device at a risk of security
exploits. This in turn has an end result of leaving the consumer
at risk to future software exploits.

3) Average consumers (non-geeks) don't know what a RADIUS
server is, so don't put the option in the box. Making a sub-class
of wireless devices geared towards everyday consumers that
leave out these very option like Port Forwarding, DMZ Zone, and
Port Triggering.

Login, set wireless security, and leave! This not only slims down
the software needed to run the wireless device, it creates a
barrier of security in the software. Security that trickles down to
the end user.

4) There is a serious need for Channel Identification Software
built into the wireless devices. This software would ensure the
best channel to choose for your wireless network by scanning all
local 802.11x channels within' 1000 ft. in every direction. Noting
the channels that are in use buy your direct neighbors that WILL
affect your wireless network if you chose to be on the same
channel as your neighbors. The fore technology would ensure
that this would never happen.

5) In the case that someone want's to be on the same channel as
your wireless network, you should be informed. Because this
kind of activity is not normal unless your trying to sniff your
neighbors packets.

In that case that a neighbor is looking for trouble and I want to
know about it in the form of a pop-up window that tells me
there is somebody using the same channel on my Wifi network,
would you like to change the channel.

The above is just suggestion and should be taken with a "grain
of salt".

~Justin
Tech01.net

[Seaspray0]

Sub Class available

Most wireless routers come with software that uses a simple wizzard to configure. Most wireless routers default to the basic settings you mention. I, for one, would not like to see all those wonderful settings for DMZ or 802.1x authentication, or MAC filter tables simply go away. Operating systems have thousands of settings that are automtically configured requiring little interaction from the user, so I can't see degrading options from that perspective. Nor can I see security improved without these features (many of which improve security if used properly). A feature that scans available channels before setting the default would be nice as there are too many out there who broadcast on channel 6... but then again, I'm enjoying my neighbors all fighting over one channel and leaving the rest free for me.

[davidroll]

Fantastic Stuff

I have used the Belkin Pre-N in my home for over a year to run a small (3 PC's 1 Laptop and a few other devices) home network, and felt as though I was cheating. The range is incredible, and the speed has been as good as a wired connection. I have never had difficulty communicating with other home Wi-Fi G or B devices including an HP wireless printer, XBox wireless adapters, and various laptops brought home for testing during a laptop replacement project at my work.

I couldn't be happier with my choice.

[rezzin1]

i have to agree belkin pre is the best so far

ive had the belkin pre n for about a year now . the first one went bad but they were awasome. they replased it with a brand new one free of charge . now thats service. i could not be happier. i havent seen any of the official n standard routers . but i might never need to . i used to work at a gas station and my friend across the street used to broacast me a wifi with my belkin router . almost never had a problem except when someone would call my cordless 900 megaherz phone . and i used the rangemax laptop card . simply great . ive tryed 4 routers and by far the belkin is the best . i cant speak for any other of there products though .

[jcbyte]

Just curious about compatibility

I just bought a new Notebook from HP with the Broadcom Pre n wireless built in. Just wondering about compatibility with the Belkin pre n router.

Any help would be appreciated.

jc

[JOHNJHOME]

N-Spec Wireless Routers

I am reading a lot of comments that state to hold off on buying the N-Spec wireless routers until the spec if finalized. Other comments I read state that this spec is still about two years away. However, most of these comments are dated at some time during 2006! I am wondering if the N-Spec wireless routers are stable at this time and if this is a good time to buy one? Does anyone have any current feedback about this? I am in need of upgrading my wireless network but I am not sure what to do at this time.